Lat Works Construction

Cleaners Prosoco Klean Custom Masonry

Use on architectural concrete block, concrete and fired clay. Always seal container after dispensing. Published shelf life assumes upright storage of sealed containers in a dry place. Klean® 600 dissolves mortar smears and construction dirt quickly, leaving the masonry clean and uniform with no acid burning or streaking.
Cleans and degreases light-to-heavily soiled stone, tile, masonry and much more.
It’s concentrated for the toughest industrial cleaning jobs on concrete, metal and many other plant and warehouse surfaces. This concentrated, general-purpose acidic cleaner improves the color and uniformity of most custom masonry and colored concrete. Removes mortar smears, heavy efflorescence, and embedded stains.
Improves penetration of protective treatments.

Prosoco Sure Klean Custom Masonry Cleaner 1 gallon

Let test area dry 3 to 7 days before inspection. This highly efficient, gelled cleaner is a colorless blend of cleaning agents, detergents and inhibitors.
This may be an error or notice that a specific variant is not available.
Method options are drawer, modal, and flip. I would have liked, and took the most scrubbing on my part. While the bricks are still wet from the second application, take a scrub brush and work from the bottom up (to avoid streaking) in small circular motions.

If your fireplace is older than 20 years, you may want to opt for a less abrasive cleaner and steer clear of the vinegar solution.


Masonry Cleaning Demonstration Prosoco – Prosoco Masonry Cleaners

Cleaners Prosoco Klean Custom Masonry. Brush




Thou shalt not clean until the mortar has cured.
Cleaning before the mortar has cured – usually within seven days – may damage the joints. Results may be unpredictable if you use the cleaner for anything else. Test each kind of surface and each kind of stain. Test under the same conditions you’ll have for cleaning. This is perhaps the most critical step in giving a building a uniform, clean appearance. The cleaner can’t soak into a thoroughly prewetted surface. As you move down a wall, cleaning as you go, make sure to prewet as you go.
Thou shalt apply the cleaner with low-pressure spray or masonry washing brush.
High-pressure spray – above 50 psi – drives the cleaner right into the brick. Stains and residue can also result from letting the cleaner “dry in” to the masonry. You can also reapply the product for an additional minute or two if the first application is drying out too quickly.
A few passes with a garden hose is not good enough. On outside surfaces, high-pressure water-rinses of at least 400 psi and four to six gallons per minute are standard. Then wipe it off with clean water and a sponge or soft-fibered brush.
Thou shalt not clean in cold weather without special precautions.
Extend dwell time by 10 -20 percent, but don’t let the cleaner dry in.
Consider scaffolding covered with polyethylene. Never try to guess your way through problems or questions. Some justification includes that it’s less expensive to hire out, expand the time frame and get it all done at the end of construction.

Contractors must allow timely cleaning tasks to be performed in the building process to reduce risks of employing cleaning methods which are too harsh for the material and damage the exterior of a building before the client even gets the keys to the front door.


Masonry Wall Cleaning Demonstration By Prosoco

PROSOCO demonstrates products and techniques to help clean masonry walls in the Masonry Innovations & Workforce …

Leave a Reply

Your email address will not be published. Required fields are marked *